IC695ETM001|Features two (2) RJ45 connectors that support Ethernet I/P communication protocols
Brand GE/Emerson
Series RX3i PacSystem
Part number IC695ETM001
Product Type Ethernet interface module
Compatibility PACSystems RX3i
Ethernet port 2 10/100 Mbps
Serial: RS-232 Yes
Serial data rate 1200 bps to 115200 bps
Hot swap Yes
Automatic sensing port Yes
Ethernet processor speed of 200 MHZ
Non-volatile memory Yes – Allows Ethernet nodes to be daisy-chain-connected
Transfer rate 10/100 Mbps
Ethernet connector 8-pin female shielded RJ45
The IC695ETM001 is a PACSystem Rx31 module manufactured by GE and recently acquired by Emerson. The IC695ETM001 is a two (2) port Ethernet transmitter module that supports Ethernet connectivity, 10/100 Mbps transfer rates and auto-negotiation.
The IC695ETM001 is a single slot module that fits into the RX3i slot. It enables PACSystem to communicate with other controller platforms, such as the 90 Series and VersaMax controllers. The module is capable of implementing the Service Request Transfer Protocol (SRTP), Modbus TCP, and Ethernet Global Data (EGD) protocols on the Layer 4 TCP/IP (Internet) stack.
The Ethernet transmitter module supports periodic data exchange over Ethernet global data, and implements EGD commands to read and write to the controller. It also supports TCP/IP services using Serial Real-time Transport Protocol (SRTP) and SRTP channels, and is able to act as both a MODBUS TCP server and a MODBUS TCP client. It has an embedded switch that can be configured for auto-negotiation, sensing, speed, and cross detection. The module can also be used for time synchronization with the SNTP time server over Ethernet TCP/IP.
The IC695ETM001 has an Ethernet processor speed of 200 MHz. It comes with LED status indicators such as Ethernet OK, LAN OK, Log Empty, single port and speed LED status indicators.
When installing the IC695ETM001, the compatible backplane is the IC695CHS007, CHS012, or CHS016. It is compatible with any other PACSystem RX3i module except the CPE400. It is best installed on an unpowered RX3i backplane, but supports insertion when powered on and even when the processor is in RUN mode. This is also known as the hot swap function. To enable hot swap, firmware version 2.51 must be installed.
An RS-232 serial port is also available on the IC695ETM001 module, supporting data rates from 1200 bps to 115200 bps. The module’s built-in Station Manager functionality is accessible via serial and Ethernet connections and provides monitoring access. The services provided through Station Manager include commands for polling and controlling the station, for monitoring access to statistics, logs, and configuration parameters, and for password security. The IC695ETM001 module can be used to synchronize time stamps of EGD exchanges over the SNTP protocol. The IC695ETM001 module features PLC configuration and programming capabilities, regular data exchange via EGD, TCP/IP communication via SRTP, and diagnostic and site management tools. The IC695ETM001 module can be installed in any empty RX3i slot. The IC695ETM001 module supports hot swap. The module firmware can be upgraded on-site through software tools provided by GE Fanuc.